Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Keene, NH

CHI Overhead Doors Garage Door Cable Repair in Keene, NH

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

Our CHI Overhead Doors garage door cable repair service in Keene, NH comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Frayed, snapped or slipped lift cables replaced and the door re-leveled. Whether your CHI Overhead Doors garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for CHI Overhead Doors garage door cable repair

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

Why this happens

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

What you can check yourself

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle CHI Overhead Doors garage door cable repair

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

CHI Overhead Doors Garage Door Cable Repair cost in Keene, NH

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

Serving Keene, NH and nearby towns

Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in New Hampshire usually start at floor level.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our CHI Overhead Doors garage door cable repair service covers Keene (ZIP codes 03431 and 03435) and nearby towns including Swanzey (4.4 mi), Chesterfield (10.2 mi), Fitzwilliam (12.6 mi) and Brattleboro, VT (15.3 mi). Call (833) 435-8883 to book a visit in Keene.

CHI Overhead Doors Garage Door Cable Repair: frequently asked questions

How much does CHI Overhead Doors garage door cable repair cost in Keene, NH?

CHI Overhead Doors Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Hampshire or Keene requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Keene, NH

Skylink Smart Garage Door Opener Setup

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $100-$900

LiftMaster Smart Garage Door Opener Setup

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $100-$900

Craftsman Garage Door Sensor Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$250

Wood Garage Door Repair

Rotted, warped or split wood sections repaired, sealed and rebalanced.

Typical $200-$700

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Richards-Wilcox Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Genie Smart Garage Door Opener Setup

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$900

Garage Door Safety Inspection

A full safety check of springs, cables, sensors and auto-reverse.

Typical $75-$150

Clopay Garage Door Repair

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$450

Midland Garage Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Haas Door Garage Door Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$450

Martin Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Garage door stuck, noisy or broken?

Talk to a garage door technician in Keene, NH now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote